{"id":682,"date":"2014-10-06T20:10:39","date_gmt":"2014-10-07T02:10:39","guid":{"rendered":"http:\/\/www.creamyradioaudio.com\/?p=682"},"modified":"2014-10-06T22:31:15","modified_gmt":"2014-10-07T04:31:15","slug":"my-mixer-setup-including-mix-minus-settings","status":"publish","type":"post","link":"https:\/\/www.creamyradioaudio.com\/?p=682","title":{"rendered":"My mixer setup, including MIX MINUS settings"},"content":{"rendered":"

\"71uzzvWiDvL._SL1000_\"<\/a><\/p>\n

Mixer is a a Behringer XENYX X2442USB Premium 24-Input 4\/2-Bus Mixer (get it HERE<\/a>).<\/p>\n

My Xenyx Berhinger mixer setup, including MIX MINUS settings<\/p>\n

Buttons on channels: <\/strong><\/p>\n

All three channels: Solo out, main in. <\/strong><\/p>\n

CHANNEL One: <\/strong>1\/2 IN. 3\/4<\/strong> IN. <\/strong><\/p>\n

CHANNEL Two: 1\/2 OUT. 3\/4 IN.<\/strong><\/p>\n

CHANNEL Three: 1\/2 IN. 3\/4 OUT.<\/strong><\/p>\n

CHANNEL <\/strong>ONE<\/strong> ON MIXER (labeled <\/strong>MWD<\/strong><\/em>): <\/strong><\/p>\n

<\/p>\n

GAIN AT 2 O’CLOCK<\/p>\n

CHANNEL TWO ON MIXER (labeled Comrex<\/em>):<\/strong><\/p>\n

GAIN AT zero<\/p>\n

CHANNEL THREE ON MIXER (labeled Skype):<\/strong><\/p>\n

GAIN AT 2 O’CLOCK<\/p>\n

ALL<\/strong> THREE CHANNELS: <\/strong><\/p>\n

low-cut button in.<\/p>\n

All compressor knobs off<\/p>\n

EQ KNOBS<\/p>\n

Channel 1: high at 2 oclock. high mid at noon. Low mid at 3 o’ clock. Low at noon<\/p>\n

Channel 2: all noon,<\/p>\n

Channel 3: all noon, except high at 2 oclock.<\/p>\n

All aux knobs off<\/p>\n

All FX knobs off.<\/p>\n

All FX pre buttons out.<\/p>\n

All Pan buttons at noon.<\/p>\n

All Mute buttons out (on channels I’m using, all other channels muted and volume slider all the way down)<\/p>\n

Volume sliders:<\/p>\n

CHANNEL below zero, middle of bottom box.<\/p>\n

CHANNEL below zero, middle of bottom box.<\/p>\n

CHANNEL below zero, middle of bottom box.<\/p>\n

TOP RIGHT area on mixer: <\/strong><\/p>\n

Aux Sends, Stereo Aux Returns: All at zero (except bottom right, phone to control room at noon, probably doesn’t need to be.)<\/p>\n

All buttons out.<\/p>\n

BOTTOM RIGHT area on mixer: <\/strong><\/p>\n

All buttons out, except Main Mix is in.<\/p>\n

Phones into Phones A. Volume up just enough to hear in phones. (Not too loud, might cause echo back to Neema.) Keep side of headphones away from mic.<\/p>\n

SUBGROUP SLIDERS <\/strong><\/p>\n

1\/5 (Comrex): above zero, in middle of top box.<\/p>\n

3\/7: (Skype) at zero<\/p>\n

2\/6 and 4\/8: off.<\/p>\n

MAIN<\/strong> MIX: <\/strong>just above between the two boxes.<\/p>\n

INPUTS <\/strong>AND<\/strong> OUTPUTS: <\/strong><\/p>\n

SUB<\/strong> OUTPUT 1 (ON BACK OF MIXER)<\/strong><\/p>\n

Into Comrex input Left via balanced 1\/4″ male to male.<\/p>\n

SUB<\/strong> OUTPUT 3 (ON BACK OF MIXER)<\/strong><\/p>\n

Into Skype computer M-Audio card’s In Left via balanced 1\/4″ male to male.<\/p>\n

CHANNEL <\/strong>ONE<\/strong> ON MIXER (<\/strong>MWD<\/strong><\/em>): <\/strong><\/p>\n

XLR input from Presonus output.<\/p>\n

CHANNEL TWO ON MIXER (Comrex<\/em>):<\/strong><\/p>\n

Balanced 1\/4″ line in from left out balanced 1\/4″ on Comrex<\/p>\n

CHANNEL THREE ON MIXER (Skype<\/em>):<\/strong><\/p>\n

Balanced 1\/4″ male from Main Out L (NOT monitor out) on Skype computer M-Audio soundcard into Balanced 1\/4″ male line in on mixer.<\/p>\n

=-=-=-=<\/p>\n

PRESONUS COMPRESSOR SETTINGS: <\/strong><\/p>\n

Gain: line 48<\/p>\n

Tube Drive: 20<\/p>\n

Thresh: halfway -22 and -28<\/p>\n

Ratio: 5 (straight up)<\/p>\n

Attack: Fast(est), all the way to left.<\/p>\n

Release: at 2 o’clock<\/p>\n

Gain: 9.<\/p>\n

Low freq: noon plus 1<\/p>\n

Low gain: noon plus 1<\/p>\n

Mid freq: noon<\/p>\n

Q: 2 notches to the right of noon<\/p>\n

Gain: noon<\/p>\n

High: freq at noon. Gain at 1 notch higher than noon<\/p>\n

Level: -40<\/p>\n

Buttons, all out (not lit) except these are in (lit):<\/p>\n

80hz cut<\/p>\n

Soft<\/p>\n

EQ>Comp<\/p>\n

GR to Meter<\/p>\n

Peak<\/p>\n

Peak<\/p>\n

=-=-=-=-=-<\/p>\n","protected":false},"excerpt":{"rendered":"

Mixer is a a Behringer XENYX X2442USB Premium 24-Input 4\/2-Bus Mixer (get it HERE). My Xenyx Berhinger mixer setup, including MIX MINUS settings Buttons on channels: All three channels: Solo out, main in. CHANNEL One: 1\/2 IN. 3\/4 IN. CHANNEL Two: 1\/2 OUT. 3\/4 IN. CHANNEL Three: 1\/2 IN. 3\/4 OUT. CHANNEL ONE ON MIXER … Continue reading “My mixer setup, including MIX MINUS settings”<\/span><\/a><\/p>\n","protected":false},"author":1,"featured_media":0,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[6],"tags":[],"class_list":["post-682","post","type-post","status-publish","format-standard","hentry","category-radiooooooo","hfeed"],"_links":{"self":[{"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=\/wp\/v2\/posts\/682","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=%2Fwp%2Fv2%2Fcomments&post=682"}],"version-history":[{"count":1,"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=\/wp\/v2\/posts\/682\/revisions"}],"predecessor-version":[{"id":683,"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=\/wp\/v2\/posts\/682\/revisions\/683"}],"wp:attachment":[{"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=%2Fwp%2Fv2%2Fmedia&parent=682"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=%2Fwp%2Fv2%2Fcategories&post=682"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.creamyradioaudio.com\/index.php?rest_route=%2Fwp%2Fv2%2Ftags&post=682"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}